MT82 Upgraded Output shaft kit
(View Product)
-
Technical
Note the torque setting for the hex bolt that holds the LR030054 part is 133 fl lbs,
-
Installation
Please click here to see the article in Land Rover Owner magazine with comprehensive fitting instructions
A tip for removing the old collar in situ with the rear casing still fitted is to weld 2 M8 nuts to the 2 cut outs then either use a slide hammer or a 2 legged puller.
Fit the LR030054 and TUD500020 as normal, put a light smear of grease on the O rings and some loctite on the female thread in the ali collar before fitting,